|
|
Corvair Dual Electronic Ignition |
|||||||||||||||||||||||||||
Page 6 |
|||||||||||||||||||||||||||
This is what your distributor should look like at this point. Get the two LED sensors and the two small silver screws from the ignition kits. |
|
|
|||||||||||||||||||||||||
Mount them loosely to the brackets |
|
||||||||||||||||||||||||||
Adjust the sensors vertically so that the shutter does not hit anything, The distributor shaft moves up and down slightly. Check the clearance at both positions so that nothing touches. Route the sensor wires around the distributor so that they will not touch the shutter wheel. Move the protective wire sheath to the Ty-wrap and slot opening. Bring them through the Ty-wrap in the point plate and tighten down. |
|
||||||||||||||||||||||||||
|
|
|||||||||||||||||||||||||||
|
|
||||||||||||||||||||||||||
