|
|
Seats |
|||||||||||||||||||||||||||
Page 1 |
|||||||||||||||||||||||||||
Here are the end support brackets for the vertical trusses under the seat (ala Mark Langford). They are epoxied and clamped |
. |
|
|
||||||||||||||||||||||||
The clamps were removed from the support brackets after they cured. You can see the seat trusses behind the aft center spar. They are made up from 1/2" urethane foam glassed with two layers of 7.5 oz fiberglass. |
|
||||||||||||||||||||||||||
Here is that photo I promised, a photo of the trusses in place. I found it while searching for all the PIX I took. . It looks as though the seat bottoms still have to go down another 1.5 inches to give me some head room. |
|
||||||||||||||||||||||||||
|
|
|||||||||||||||||||||||||||
|
|
||||||||||||||||||||||||||
