|
Front Deck
|
|
Page
1
|
|
|
The Trymer 2000 glued in place
using the spray foam. After letting it cure the clamps were removed and
the front deck was sanded to shape.
|
|
|
|
|
|
|
The full size CAD plot of
my instrument panel was glued onto a piece of 3/8" plywood to use
as a sanding reference. I had drawn this panel before I started on the
fuselage. Now that is was placed in position I found out that most every
thing has to move 1.5 - 2" to the right. The final width is slightly
smaller than the drawing and the fresh air outlets need to be raised.
|
|
|
|
|
|
The frontdeck was sanded very
quickly. The duct tape was used as a release agent so that the fiberglass
would not be permanently bonded to the fuselage.
|
|
|
|
|
|
|
| |
|
|
|
|
|
