|
|
Micro Monitor Assembly |
|||||||||||||||||||||||||||
Page 4 |
|||||||||||||||||||||||||||
Following the steps in the Assembly manual bend the leads to the resistor at 90 degrees keeping the value facing up. |
|
|
|||||||||||||||||||||||||
Insert the resistors into the card and bend the leads slightly apart to keep them from falling out. Solder all the leads and then clip with the flush cut nippers. Inspect for good solder joints. Fix any that don't pass. |
|
|
|||||||||||||||||||||||||
Repeat for the large PC card.
|
|
||||||||||||||||||||||||||
|
|
|||||||||||||||||||||||||||
|
|
||||||||||||||||||||||||||
